IBM Power System 9008-22L Manual

Also see for 9008-22L: Site and Hardware Planning Manual Manual Manual Manual

Where locationcode is replaced with the location you identified earlier. For example,U7879.001.DQD014E-P1-C3.The following screen is displayed.The visual indicator for the specified PCI slot has been set to theidentify state. Press Enter to continue or enter x to exit.2) Physically verify that the slot you identified is where you want to remove the adapter.Notes:• Use the blue identify LED on the enclosure to locate the system. Ensure that the serialnumber of the system matches the serial number to be serviced.• Look for the flashing amber LED, which identifies the slot that was selected by using theidentify function.3) Press Enter. The slot is ready to have a PCIe adapter removed. Continue to follow theseinstructions until you are told to remove the adapter.10. Label and disconnect all of the cables or transceivers that are attached to the adapter you plan toremove.Use a hook-and-loop fastener to hold the cables in place.11. If the cable management arm is open, close it by completing the following steps:a) Swing the cable management arm towards the server.b) Insert the inner cable management arm tab (A) into the outer mounting bracket (B) until it clicksinto place as shown. The inner mounting bracket (C) is not used on the left side.34 Power Systems: PCIe adapters for the 9008-22L, 9009-22A, or 9223-22H