IBM Power System 9008-22L Manual

Also see for 9008-22L: Site and Hardware Planning Manual Manual Manual Manual

Note: The operation will create new namespaces on the selected NVMe device, pair the newnamespaces with the suspended NVMe disk units, and start to resume mirror protection on thenewly created disk units.i) Press F12 to return to the SST main menu.19. Continue with step “21” on page 47.20. If you are using the Linux operating system, complete the following steps:a) In the Linux session on the console, press Enter after you install or replace the adapter to put theslot into the action state.b) Enter the slot information with the lsslot command, as shown in the following example.For example, if the slot in which you installed the PCIe adapter was U7879.001.DQD014E-P1-C3.Enter lsslot -c pci -s U7879.001.DQD014E-P1-C3The following screen is an example of the information that is displayed by this command:# Slot Description Device(s)U7879.001.DQD014E-P1-C3 PCI-X capable, 64 bit, 133MHz slot 0001:40:01.021. Verify the installed part.• If you replaced the part because of a service action, verify the installed part. For instructions, seehttps://www.ibm.com/support/knowledgecenter/POWER9/p9ect/pxect_verifyrepair.htm (www.ibm.com/support/knowledgecenter/POWER9/p9ect/pxect_verifyrepair.htm).• If you installed the part for any other reason, verify the installed part. For instructions, see https://www.ibm.com/support/knowledgecenter/POWER9/p9haj/pxhaj_hsmverify.htm (www.ibm.com/support/knowledgecenter/POWER9/p9haj/pxhaj_hsmverify.htm).22. Turn off the identify LED. For instructions, see Deactivating an identify LED (www.ibm.com/support/knowledgecenter/POWER9/p9haj/p9haj_turn_off_identify_led.htm).23. If you replaced a Fibre Channel adapter, the customer might need to update the Fibre Channel SASpath to the external storage subsystems with the new WWPN number or numbers.Permanently removing a PCIe adapter from the 9008-22L, 9009-22A, or9223-22H systemFind information about permanently removing Peripheral Component Interconnect Express (PCIe)adapters from the system.About this taskNote: Removing or replacing this feature is a customer task. You can complete this task yourself, orcontact a service provider to complete the task for you. You might be charged a fee by the serviceprovider for this service.If your system is managed by the Hardware Management Console (HMC), use the HMC to repair a part inthe system. For instructions, see Repairing a part by using the HMC (www.ibm.com/support/knowledgecenter/POWER9/p9haj/p9haj_hmc_repair.htm).If your system is not managed by an HMC, complete the steps in the following procedures to permanentlyremove a PCIe adapter from the system.Installing, removing, and replacing PCIe adapters in the 9008-22L, 9009-22A, or 9223-22H system 47