IBM Power System 9008-22L Manual

Also see for 9008-22L: Site and Hardware Planning Manual Manual Manual Manual

Figure 34. Closing the cable management arm10. If applicable, open the rack front door.11. Open the side latches (A) and pull the latches to slide the system unit fully into the service position,until the slides click and hold the system unit securely. Ensure that the screws inside the latches arenot secured to the rack.Remove the hook-and-loop fasteners that secure the cable management arms. Ensure that the cablemanagement arms can move freely. Ensure that the cables at the rear of the system do not catch orbind as you pull the system unit into the service position.Do not pull out or install any drawer or feature if the rack stabilizer brackets are not attached to therack. Do not pull out more than one drawer at a time. The rack might become unstable if you pull outmore than one drawer at a time.Installing, removing, and replacing PCIe adapters in the 9008-22L, 9009-22A, or 9223-22H system 53