IBM Power System S822 Installing Instructions

Also see for Power System 8284-22A: Manual Manual Manual Manual Manual

Cabling the server and accessing Operations Console:You can use Operations Console to manage a server that is running the IBM i operating system whetheryou have logical partitions or not. However, you must first use an alternative tool to create the logicalpartitions.Operations Console is a component of IBM i Access for Windows. You can install the complete product orselect only the two console components, which are the Operations Console support and the 5250emulator support.To prepare to cable the server and access the Operations Console, complete the following steps:1. Ensure that your server is powered off.2. Obtain a static IP address that is assigned to the LAN console adapter on the server for use by theconsole, including information about the IP, subnet mask, and default gateway.3. Select a unique host name and register the host name and the IP address in your site's Domain NameSystem (DNS).Note: This IP address is for use by Operations Console and different from the IP address that is usedto connect a normal Telnet session. The IP address must not be in use by another server. Ping the IPaddress to verify that no other device is using the IP address.To learn more about setting up Operations Console, complete the following steps:1. Install IBM i Access for Windows and the latest service pack.Note: The list of Microsoft Windows operating systems that are supported for Operations ConsoleLAN is documented at: IBM i Access (http://www-03.ibm.com/systems/i/software/access/windows/supportedos.html).a. Log on to the system as a local administrator.b. Ensure that you install the latest IBM i Access service pack. The website to download the latestservice pack for IBM i Access can be found at IBM i Access (http://www-03.ibm.com/systems/i/software/access/windows/casp.html).2. Cable the PC to server. Plug a Cat 5e or Cat 6 (recommended) Ethernet cable from the PC directlyinto a valid Ethernet adapter port. To determine the server adapter port that you must use, refer tothe following table:Table 4. Server Operations Console LAN portsServer Operations Console - LAN port Note8286-41A C2, C3, C4, C5, C6, and C7 You must cable to the top port of a5767/5768/5899 in a "base-slot".Note: Make the initial connection with the PC directly cabled to the server. The PC and server can berecabled to the network after the initial connection is made. A cross-over cable is not needed. Forinformation, see Adapter requirements (http://www.ibm.com/support/knowledgecenter/POWER8/p8hbx/hardwarereq_adapter.htm).3. Configure the PC networking. To configure the PC networking, complete the following steps:a. Disable any additional listed, except the local area connection.b. Record current TCP/IP settings:1) Access the adapter properties. Select Internet Protocol, then click Properties.2) Record the current settings, including IP address, subnet mask, and gateway, if applicable.c. Change the TCP/IP settings.14 Power Systems: Installing the IBM Power System S822 (8284-22A)