IBM Power System S822 Installing Instructions

Also see for Power System 8284-22A: Manual Manual Manual Manual Manual

Note: It might take up to 2 minutes for the ASMI login display to be shown in the Web browser afterthe Ethernet cable is plugged into the service processor in step 3 on page 37. During this time, if youuse control panel function 30 to view the IP addresses on the service processor, incomplete orinaccurate data is shown.7. When the Login display appears, enter admin for the user ID and password.8. Change the default password when prompted.9. Choose from the following options:v If you do not plan to connect your PC or notebook to your network, this ends this procedure. Youcan now perform tasks such as changing the time of day or changing the altitude setting.v If you plan to connect your PC or notebook to your network, see Accessing the ASMI without anHMC (http://publib.boulder.ibm.com/infocenter/systems/scope/hw/topic/p8hby/connect_asmi.htm).Setting the IP address on your PC or notebookTo access the Advanced System Management Interface (ASMI) through a web browser, you first need toset the IP address on a PC or notebook. The following procedures describe setting the IP address on a PCor notebook that is running the Linux operating system and the Microsoft Windows XP, 2000, and Vistaoperating systems.You need the information that you recorded in step 4 on page 37 in the “Accessing the ASMI by using aweb browser” on page 36 topic to complete the following procedure.Windows VistaTo set the IP address within Windows Vista, complete the following steps:1. Click Start > Control Panel.2. Ensure Classic View is selected.3. Click Network and Sharing Center.4. Click View status in the Public network area.5. Click Properties.6. If the Security window is shown, click Continue.7. Highlight Internet Protocol Version 4 and click Properties.8. Select Use the following IP address.9. Complete the IP address, Subnet mask, and Default gateway fields by using the values that yourecorded in the “Accessing the ASMI by using a web browser” on page 36 topic.10. Click OK > Close > Close.Windows 7To set the IP address within Windows 7, complete the following steps:1. Click Start > Control Panel > Network and Internet > Network and Sharing Center.2. Click Change adapter settings to choose your network adapter.3. Right-click the adapter and choose Properties to open up the properties window.4. Select Internet Protocol Version 4(TCP/IPv4), and then click Properties.Attention: Record the current settings before you make any changes. Use this information to restorethese settings if you disconnect the PC or notebook after you set up the ASMI web interface.5. Select Use the Following IP Address.6. Complete the IP address, Subnet mask, and Default gateway fields by using the values that yourecorded in the “Accessing the ASMI by using a web browser” on page 36 topic.7. In the Local Area Connection Properties window, click OK. It is not necessary to restart your PC.38 Power Systems: Installing the IBM Power System S822 (8284-22A)