v Remotely accessing the server, using the keyboard and mouse from a remoteclientv Mapping the CD or DVD drive, diskette drive, and USB flash drive on a remoteclient, and mapping ISO and diskette image files as virtual drives that areavailable for use by the serverv Uploading a diskette image to the IMM memory and mapping it to the server as avirtual driveThe blue-screen capture feature captures the video display contents before the IMMrestarts the server when the IMM detects an operating-system hang condition. Asystem administrator can use the blue-screen capture to assist in determining thecause of the hang condition.Enabling the remote presence featureTo enable the remote presence feature, complete the following steps:1. Install the virtual media key into the dedicated slot on the system board (see“Installing an IBM Virtual Media Key” on page 52).2. Turn on the server.Note: Approximately 40 seconds after the server is connected to ac power, thepower-control button becomes active.Obtaining the IP address for the Web interface accessTo access the Web interface and use the remote presence feature, you need the IPaddress for the IMM. You can obtain the IMM IP address through the Setup utility.To locate the IP address, complete the following steps:1. Turn on the server.Note: Approximately 40 seconds after the server is connected to ac power, thepower-control button becomes active.2. When the prompt Setup is displayed, press F1. If you have set both apower-on password and an administrator password, you must type theadministrator password to access the full Setup utility menu.3. From the Setup utility main menu, select System Settings.4. On the next screen, select Integrated Management Module.5. On the next screen, select Network Configuration.6. Find the IP address and write it down.7. Exit from the Setup utility.Logging on to the Web interfaceTo log on to the Web interface to use the remote presence functions, complete thefollowing steps:1. Open a Web browser on a computer that connects to the server and in theAddress or URL field, type the IP address or host name of the IMM to whichyou want to connect.Notes:a. If you are logging in to the IMM for the first time after installation, the IMMdefaults to DHCP. If a DHCP host is not available, the IMM uses the defaultstatic IP address 192.168.70.125.100 System x3620 M3 Type 7376: Installation and User’s Guide