If you have other devices to install or remove, do so now. Otherwise, go to“Completing the installation” on page 83.Installing an optional tape drive cageThe IBM System x3620 M3 tape drive enablement kit is used to install an optionaltape drive cage in an IBM System x3620 M3 server. See http://www.ibm.com/servers/eserver/serverproven/compat/us/ for a list of supported optional devices. Toorder a tape drive enablement kit, contact your IBM marketing representative orauthorized reseller. The IBM System x3620 M3 tape drive enablement kit iscompatible only with the following tape drives:v IBM DDS Generation 5 (DDS/5) SATA tape drivev IBM DDS Generation 6 (DDS/6) USB tape driveThe IBM System x3620 M3 tape drive enablement kit contains the followingcomponents:v One USB signal cable and one power cable, or one SATA-power combo cablev One tape drive cageTo install the optional tape drive cage, complete the following steps:1. Read the safety information that begins on page vii and “Installation guidelines”on page 31.2. Turn off the server and peripheral devices, and disconnect the power cord andall external cables (see “Turning off the server” on page 19).3. Remove the server cover (see “Removing the cover” on page 40).4. Remove the air baffle (see “Removing the air baffle” on page 41).5. Remove the PCI riser-card assembly (see “Removing the PCI riser-cardassembly” on page 42).6. Loosen the thumbscrew that secure the drive filler cage to the chassis; then,push the drive filler cage out of the bay to remove it from the server.60 System x3620 M3 Type 7376: Installation and User’s Guide