d. Press F7 to store the data.e. Press F14 to activate the adapter for use by Operations Console.14. Press F3 until you return to the DST main menu.ResultsThe system is now configured for use by Operations Console local console on a network when an actionis taken to search for a new console. This could include an IPL, the native macro, or the console servicefunction (65+21). Do NOT take an action to switch to the new console until you have satisfied anynecessary PC configurations. If you do not plan to use the local console directly attached configuration asa backup console, you do not need to remove or move its adapter at this time. You may need it to debugproblems.The system value QAUTOCFG must be set to on. Use one of the following methods to verify or set thissystem value:v Use the WRKSYSVAL QAUTOCFG command.v During a manual IPL, in the IPL Options window, select Y for Set major system options. Then, forEnable automatic configuration, select Y.Related tasks“Configuring the PC to use the new console type when changing from a local console directlyattached to a local console on a network”To change from an Operations Console with local console directly attached to a local console on anetwork (LAN), you must configure the PC to use the new console type.Related reference“Operations Console hardware requirements” on page 7You need to meet the PC and System i hardware requirements for an Operations Consoleconfiguration.Related informationAccess service toolsConfiguring the PC to use the new console type when changing from a local console directly attachedto a local console on a network:To change from an Operations Console with local console directly attached to a local console on anetwork (LAN), you must configure the PC to use the new console type.About this taskFollow these steps on the PC:1. Disconnect the current console connection. To disconnect, do the following:a. Under System i Connection, select the configuration name. This is the name that OperationsConsole uses to refer to a specific system.b. From the Connection menu, click Disconnect. The connection status shows Disconnecting.c. Wait for the status to show Disconnected.2. Configure the new console type. It is preferred that you perform an initial program load (IPL) to becertain there are no errors.Once you are satisfied that the new console is working correctly, you can proceed with any plans tomove or remove any adapter or configurations.Operations Console 55
