4 = MinimumThe dump will include the smallest amount of information possible (a minimum number ofhardware scan log rings).The complete dump will take the longest time to finish; it may take as long as 1.5 hours on a fullyconfigured system.The scan log dump content can also be set from the Tasks menu in the AIX diagnostic service aids.If a valid dump file already exists, the dump control code will stop because the contents of the prior dumpmust be protected.Option 3, Immediate Dump, can only be used when the system is in the standby state with power on. It isused to dump the system data after a checkstop or machine check occurs when the system firmware isrunning, or when the operating system is booting or running.System Power Control MenuThis menu is used to set power control options. Other menus that control boot options are available fromthis menu.SYSTEM POWER CONTROL MENU1. Enable/Disable Unattended Start Mode:Currently Enabled2. Ring Indicate Power-On Menu3. Reboot/Restart Policy Setup Menu4. Power-On System5. Power-Off System6. Enable/Disable Fast System BootCurrently Fast Boot7. Boot Mode Menu98. Return to Previous Menu99. Exit from Menus0>v Enable/Disable Unattended Start ModeUse this option to instruct the service processor to restore the power state of the server after atemporary power failure. This option is intended to be used on servers that require automatic power-onafter a power failure.v Ring Indicate Power-On MenuThis function is not available on this system.v Reboot/Restart Policy Setup MenuThe following menu controls the Reboot/Restart Policy:Chapter 4. Using the Service Processor 27
