A single-power-supply server operating at 208 V acOne power supply operating at 208 V ac supports a fully populated server, but itdoes not support power or cooling redundancy.System reliability guidelinesTo help ensure proper cooling and system reliability, make sure that the followingrequirements are met:v Each of the drive bays has a drive or an electromagnetic compatibility (EMC)shield installed in it.v If the server has redundant power, each of the power-supply bays has a powersupply installed in it.v There is adequate space around the server to allow the server cooling system towork properly. Leave approximately 50 mm (2.0 in.) of open space around thefront and rear of the server. Do not place objects in front of the fans. For propercooling and airflow, replace the top cover before you turn on the server.Operating the server for extended periods of time (more than 30 minutes) withthe top cover removed might damage server components.v You have followed the cabling instructions that come with optional adapters.v You have replaced a failed fan within 48 hours.v You have replaced a hot-swap drive within 2 minutes of removal.v For redundant and hot-swappable power supply operation, the power suppliesare connected to 200-240 V ac.v Microprocessor sockets 1 - 4 each always contain either a heat-sink blank or amicroprocessor and heat sink.Working inside the server with the power onAttention: Static electricity that is released to internal server components whenthe server is powered on might cause the server to halt, which might result in theloss of data. To avoid this potential problem, always use an electrostatic-dischargewrist strap or other grounding system when you work inside the server with thepower on.The server supports hot-swap devices and is designed to operate safely while it isturned on and the cover is removed. Follow these guidelines when you work insidea server that is turned on:v Avoid wearing loose-fitting clothing on your forearms. Button long-sleeved shirtsbefore you work inside the server; do not wear cuff links while you are workinginside the server.v Do not allow your necktie or scarf to hang inside the server.v Remove jewelry, such as bracelets, necklaces, rings, and loose-fitting wristwatches.v Remove items from your shirt pocket, such as pens and pencils, that might fallinto the server as you lean over it.v Avoid dropping any metallic objects, such as paper clips, hairpins, and screws,into the server.Handling static-sensitive devicesAttention: Static electricity can damage the server and other electronic devices.To avoid damage, keep static-sensitive devices in their static-protective packagesuntil you are ready to install them.Chapter 2. Installing optional devices 27