The following illustration shows the locations of the input and output connectors onthe rear of the server.ACDC!SystemmanagementEthernetSystemserialVideo USBGigabitEthernet 1 - 2PowerconnectorACDC!QPIports1 - 2QPIports3 - 4Updating the server configurationWhen you start the server for the first time after you add or remove a device, youmight receive a message that the configuration has changed. The Setup utilitystarts automatically so that you can save the new configuration settings. For moreinformation, see Chapter 3, “Configuring the server,” on page 61.Some optional devices have device drivers that you must install. For informationabout installing device drivers, see the documentation that comes with each device.The server comes with at least one microprocessor. If more than onemicroprocessor is installed, the server can operate as a symmetric multiprocessing(SMP) server. You might have to upgrade the operating system to support SMP. Formore information, see “Typical operating-system installation” on page 69 and theoperating-system documentation.If the server has an optional RAID adapter and you have installed or removed ahard disk drive, see the documentation that comes with the RAID adapter forinformation about reconfiguring the disk arrays.For information about configuring the integrated Gigabit Ethernet controller, see“Configuring the Broadcom Gigabit Ethernet controller” on page 72.60 IBM System x3850 X5 and x3950 X5 Types 7145 and 7146: Installation and User’s Guide
