IBM x3850 X5 7145 Installation And User Manual

Also see for System x3950 X5: Installation and user guide Implementation guide Installation and user guide Problem determination and service guide

Contents

Heat sinkClipsTabsTabsClips12. Remove the heat sink from its package and rotate the heat-sink handle to thefully open position.13. Remove the cover from the bottom of the heat sink.14. Position the heat sink above the microprocessor and align the clips of the heatsink with the tabs next to the microprocessor socket.15. Press on the top of the heat sink and rotate the lever to the closed position.If you have other devices to install or remove, do so now. Otherwise, go to“Completing the installation.”Completing the installationTo complete the installation, complete the following steps:1. If you removed the front bezel, slide the bezel onto the front of the serverchassis.2. If you removed the top-cover bracket, reinstall it. Slide the blue latches into thelocked position.3. Place the top cover over the top of the server.4. Slide the top cover forward; then, press down on the cover handle until it clicksinto place.5. Connect the cables and power cords to the rear of the server. For moreinformation, see “Connecting the cables.”Connecting the cablesNotes:1. Be sure to turn off the server before you connect any cables to or disconnectany cables from the server.2. For additional cabling instructions, see the documentation that comes with theoptional devices. It might be easier for you to route any cables before you installcertain optional devices.Chapter 2. Installing optional devices 59