CAUTION:When replacing the battery, use only IBM Part Number 33F8354 or an equivalenttype battery recommended by the manufacturer. If the server has a modulecontaining a lithium battery, replace it only with the same module type made bythe same manufacturer. The battery contains lithium and can explode if notproperly used, handled, or disposed of.Do not:v Throw or immerse into waterv Heat to more than 100°C (212°F)v Repair or disassembleDispose of the battery as required by local ordinances or regulations.Do the following to replace the battery:1. Read “Before you begin” on page 40, and follow any special handling andinstallation instructions supplied with the replacement battery.2. Turn off the server and peripheral devices and disconnect all external cablesand power cords; then, remove the server cover.3. Remove the battery:a. Use one finger to press the top of the battery clip away from the batteryuntil the battery releases upward from the socket.b. Lift and remove the battery from the battery socket.4. Do the following to insert the new battery:a. Tilt the battery so that you can insert it into the socket under the batteryclip.b. As you slide it under the battery clip, press the battery down into thesocket.5. Reinstall the server cover and connect the cables.6. Turn on the server.7. Start the Configuration/Setup Utility program and set configurationparameters.v Set the server date and time.v Set the power-on password.v Reconfigure the server.16 xSeries 200 Type 8479 and xSeries 200VL Type 8481: Hardware Maintenance Manual
