IBM xSeries 200 Hardware Maintenance Manual

Also see for xSeries 200: Hardware Maintenance Manual Hardware Maintenance Manual

Contents

Table 4. NetWare driver messages for the Ethernet controller (continued)Message DescriptionError locating device controltable (DCT) addresses ininternal table. Make sure thatyou have loaded LANdrivers after loadingAFT.NLM.Explanation: The bind command was entered prior toloading the device driver. The device driver must be loadedafter loading AFT.NLM, but before any bind command canbe issued.Action: Load the driver for the supported adapter and tryloading the AFT module again. If the problem persists,contact your network supplier.Insufficient number ofarguments specified.Explanation: The appropriate or expected number ofparameters was not entered in a command.Action: Check the parameters required for the givencommand. If the problem persists, contact your networksupplier.Duplicate slot numbersdetected.Explanation: An attempt has been made to bind the sameslot number more than once.Action: Check the slot numbers entered during the bind.Adapter slot numbers must be valid and unique. If theproblem persists, contact your network supplier.’xxx’ is not supported forAFT team.Explanation: A bind command has been issued for adaptersnot supported by AFT.NLM.Action: Make sure that you attempt to bind only adapterssupported by AFT.NLM.Primary and Secondaryadapters do not match. AFTgroup is not created.Explanation: A bind command was entered for an adapterteam that is a combination of server and client adapters. AnAFT team must be a grouping of the same classification ofadapter.Action: Verify that all the adapters bound in a team are ofthe same classification.Requested number ofSecondary cards are notfound.Explanation: The number of adapters specified in the bindcommand could not be located.Action: Verify the numbers and slot locations of theadapters to be bound. If the problem persists, contact yournetwork supplier.Failed to create AFT group.Make sure that the driversfor supported adapters areloaded, primary adapter isbound to protocols, andsecondary adapter is notbound to any protocols.Explanation: Binding of protocol failed. Protocol is eithernot bound to any adapter or is bound to more than oneadapter in the group.Action: Ensure that the protocol is bound to only adapter inan AFT team.Error identifying slotnumbers for the specifiedboard names.Explanation: The mapping between the board name enteredand the slot number for an adapter could not beestablished.Action: Check the board name for the adapter beforeissuing the bind command. If the problem persists, contactyour network supplier.Can’t unbind specified slotfrom AFT group. Make surethat the slot you specified isfor the primary adapter in anAFT group.Explanation: The number entered in the unbind commandwas not the primary adapter in an AFT group.Action: Reissue the unbind command and specify the slotnumber for the primary adapter.20 xSeries 200 Type 8479 and xSeries 200VL Type 8481: Hardware Maintenance Manual