IDEC MicroSmart pentra FC5A-C10R2 User Manual

Contents

IDEC MicroSmart pentra FC5A-C10R2 User Manual Manual pdf 413 page image

FC5A MICROS MART U SER’ S MANUAL FC9Y-B1268 13-113: TROUBLESHOOTINGIntroductionThis chapter describes the procedures to determine the cause of trouble and actions to be taken when any trouble occurswhile operating the MicroSmart.The MicroSmart has self-diagnostic functions to prevent the spread of troubles if any trouble should occur. In case of anytrouble, follow the troubleshooting procedures to determine the cause and to correct the error.Errors are checked in various stages. While editing a user program on WindLDR, incorrect devices and other data arerejected. User program syntax errors are found during compilation on WindLDR. When an incorrect program is down-loaded to the MicroSmart, user program syntax errors are still checked. Errors are also checked at starting and duringoperation of the MicroSmart. When an error occurs, the error is reported by turning on the ERR LED on the MicroSmartand an error message can be viewed on WindLDR. Error codes can also be read on the HMI module.PWRRUNERRSTAT0 1 2 3 4 5 7 106 110 1 2 3 4 5 6 7 10 11 12 13 14 15OUTINERR LEDERR LEDThe MicroSmart CPU module has an error indicator ERR. Whenan error occurs in the MicroSmart CPU module, the ERR LED islit. See the trouble shooting diagrams on page 13-11.For error causes to turn on the ERR LED, see page 13-4.Reading Error DataWhen any error occurs during the MicroSmart operation, “Error” is indicated and error details can be read usingWindLDR on a computer.Monitoring WindLDR1. From the WindLDR menu bar, select Online > Monitor > Monitor. The monitor mode is enabled.2. From the WindLDR menu bar, select Online > Status. The PLC Status dialog box appears.When any error exists, “Error” is displayed in the error status box.Error Status BoxD8005 (general error code)Details ButtonSystem Program VersionD8029Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com