IDS 1632 Installer Manual

Also see for 1632: User manual User manual

Contents

IDS 1632 Installer Manual 700-256-02K Issued September 2009 16To default the ID of ALL keypads:Programming a value of [3] into location [0] causes ALL keypads to be defaulted.[INSTALLER CODE] [*] [0] [*] [3] [*]On pressing the final [*], wait a few seconds and ALL the keypads will begin flashing. (Do NOT press [#]at the end of this sequence, unless you wish the keypad you are using to be registered in the firstaddress)Re-enrol all keypads by pressing [#] on each keypad – in the CORRECT sequence to ensure thatkeypad zone and partition allocation is as required by the user.5. Event LogA comprehensive log of the 700 most recent events is retained in the non-volatile EEPROM. The log maybe retrieved using the up/ download software. Alternatively, it can be viewed using an LCD keypad. (SeeLCD Keypad Manual)NOTE:The exact number of events that can be stored is dependant on the event timing, which means it can varybetween 300 and 1000 events, practically averaging out to be of the order of 500 events.6. Download CodeThe download code (in conjunction with the installer code) is required for download access. The defaultdownload code is 9999. Using the downloading software, it is possible to program a location that willeither allow or disallow defaulting of the download code.This location is only accessible using the download software. If the panel is defaulted, thedownload code will revert back to 9999. A value of [1] [0] programmed into this location will prevent thedownload code from being defaulted when defaulting the panel.6.1 Programming the PanelThe panel can be programmed either via a keypad or via the up/ download software. Programming thepanel by means of an LED keypad is explained below:NOTE:Before commencing programming, it is advisable to read the Installer Manual thoroughly.6.2 Location ValuesAll values within a program location will be displayed by the zone indicators in binary coded decimalformat i.e. zone indicators 1-4 indicate units (1’s) and zone indicator 5-8 indicate tens (10’s), and so on.To read a binary value on the keypad sum the values represented by each on LED as shown in Table 1: