IDS LCD Digital Keypad User Manual

Also see for 1632: Installer manual User manual

IDS LCD Digital Keypad User Manual Manual pdf 15 page image

15IDS LCD Keypad User Manual 700-292-01C Issued March 20098.1 Adding, Deleting and Editing User CodesHold [*] + [MASTER USER CODE] + [*] + [PROGRAMMABLE OPTION] + [*]All IDS Alarm Panels utilise a user-friendly programmable interface which allows the user to add, modify,or delete user codes. See Table 3 for a summary of programmable options. The programmable interfaceis accessed by entering the USER PROGRAMMING MODE.Table 3 : User Programming OptionsOptions Summary of Programmable Options 816 1224 1632Option 0 Allows for the addition of new user codes. x x xOption 1 Allows editing of the user name displayed by LCD keypads.This menu is only applicable if LCD keypads are installed.x x xOption 2 Allows editing of a selected user code. Note that the usercode properties are not edited, only the user code itself.x x xOption 3 Allows viewing of the user code slot number for a selectedcode.x x xOption 4 Allows editing of the user code properties for a selecteduser code. This is a bitmapped menu.x x xOption 5 Allows the allocation of a selected user code to adesignated partition(s). This is a bitmapped menu.x x xOption 6 Assign User Code to Doors (bitmapped) xOption 7 Assign a User Code to a Schedule xOption 8 Allows a remote to be assigned to a specific user x x xOption 9 Allows a user to be deleted x x xOption 10 Allows the deletion of a user code using the user code slotnumber.x x xOption 11 Allows viewing of a user name if the slot number is known. x x xOption 12 Add User by Slot Number x xNB:Text prompts displayed on LCD Keypads connected to the IDS 1224 and IDS 1632 are considerablymore detailed than text prompts displayed on the IDS 816 Alarm Panel.8.2 How to Enter the User Program Mode1. Ensure that the panel is not armed.2. Hold down the [*] key until the keypad buzzer sounds. The ARM indicator will flash.3. The LCD prompt reads 'Enter Master Code'. The factory default is [1234]. Should the [MASTERUSER CODE] be set to six digits it will be [123456] by default.4. After entering the [MASTER USER CODE], press the [*] key. A valid entry will be confirmed bya long beep. If an invalid [MASTER USER CODE] was entered, the keypad buzzer will give anerror beep (3 short beeps).If steps 1 - 4 are performed correctly:5. IDS 816 PanelThe LCD display will prompt for a 'Menu Option'.