IDS LCD Digital Keypad User Manual

Also see for 1632: Installer manual User manual

IDS LCD Digital Keypad User Manual Manual pdf 24 page image

24IDS LCD Keypad User Manual 700-292-01C Issued March 2009to scroll through the list of programmable options until you reach menu option 11. Press the [*]to confirm your selection.3.3. Enter the [USER SLOT] followed by the [*] key.4. The USER NAME will be displayed. Default names are displayed as the SLOT NUMBER (i.e. Ifthe SLOT NUMBER has not been edited as per Option 1)5. To view another USER NAME press [*] and repeat steps 3 & 4.6. Press [#] to exit User Program Mode.8.3.13 Option 12 - Add User Slot(Not applicable to the IDS 816)Hold [*] + [Master Code] + [*] + [1] + [2] + [*] + [Slot Number] + [*] + [New User Code]+[*]1. Enter the User Program Mode as per steps 1 - 4 of (8.2).2. Menu option 0 will be displayed on the LCD Display by default. To select menu option 12 - 'AddUser Slot' press the [1] key followed by the[2] key or alternatively use the [PANIC] or [MED]keys to scroll through the list of programmable options until you reach menu option 12.3. Press the [*] to confirm your selection.4. Enter the [SLOT NUMBER] followed by the [*] key.5. Enter the [NEW USER CODE] followed by the [*] key.6. To add additional user codes repeat steps 4 & 5.7. Press [#] to exit User Program Mode.9. "Stay Zones"Stay zones are those zones which are bypassed automatically when the system is "STAY ARMED". Toavoid triggering the alarm, zones such as bedrooms which are protected by Passive Infra-Red (PIR)detectors or windows which may be opened, must be bypassed when "staying at home". Stay zonesneed only be programmed once. Each time the system is armed in the Stay Mode the pre-selected stayzones will be bypassed automatically. The panel allows for two unique STAY PROFILES to be stored. ASTAY PROFILE stores a preselected combination of STAY and BUZZ zones to suit a specific STAY ARMrequirement. If a partition is stay armed using Profile 1, it is possible to toggle the panel arm statusdirectly to stay arm profile 2 by holding the [5] key for two seconds. STAY and BUZZ zones can beprogrammed for each profile once the profile has been selected. See section 9 & 10.9.1 How to Select a Stay Profile[#] + [MODE] + [2] + [*] + [PROFILE NUMBER] + [*]1. Press the [#] key to clear any previous entries.2. Hold [MODE] down for one second until the keypad beeps twice.3. When prompted for the 'Mode' press the [2] key followed by the [*] key.4. When prompted to 'Select Profile' press [1] or [2] for the required profile.5. Press [*] to enter. The buzzer will give a long beep.6. Program STAY and BUZZ zones for the profile or ARM the profile (See sections 10 and 11).9.2 How to Program Stay ZonesHOLD [3] + [ZONE NUMBER] + [*] + [#]