IDS LCD Digital Keypad User Manual

Also see for 1632: Installer manual User manual

IDS LCD Digital Keypad User Manual Manual pdf 28 page image

28IDS LCD Keypad User Manual 700-292-01C Issued March 200913. Changing a PartitionTo change partitions the keypad must be assigned to access the required partition.1. Hold [MODE] until the keypad beeps.2. Press [1] [*].3. When prompted by the display to 'Select Partition' press [partition number] [*]The keypads may be partitioned to remain in the new partition. Any value outside of these constraints willresult in a key entry error occurring.Feature IDS 816 IDS 1224 IDS 1632Partition 1 - 2 1 - 4 1 - 8Zone 1 - 16 1 - 24 1 -32Output 1 - 7 1 - 10 1 - 12Doors 0 0 1 - 141 4 . Remote Telephone AccessPlease note that this section is only relevant if programmed by your installer.The IDS Alarm Panels have a secure, remote telephone interface which allows a user to arm/disarm, tobypass/un-bypass zones and to set programmable outputs via a phone line. A user accesses the remotedial-in interface by dialling the Alarm Panel using a DTMF phone.To access the remote dial-in interface, dial the Alarm Panel, and wait the number of rings programmed(the default number of rings being 15). If the fax defeat function has been enabled, dial the panel andhang up after one ring. Dial in again within 1 minute, the panel will pick up immediately and transmithandshake tones consisting of a high pitch tone for two seconds followed by a lower pitch tone for onesecond.Within twenty seconds of the panel transmitting the handshake tones, enter a valid user code on theDTMF enabled phone. If a user code is not entered or if the user code is invalid - the panel will releasethe line. If the user code is valid and telephone access has been enabled, the panel will give a singleconfirmation beep indicating that the user has gained access to the remote interface. If no key-pressesare detected for twenty seconds once access has been gained to the remote interface the panel willrelease the line.Should the panel be programmed to report to your cellular telephone, entering the user code in the delaybetween beeps will also allow access to the remote telephone interface.If the phone in access has been setup to arm/disarm only, pressing the number of the partition allows theuser to toggle the panels arm status.A single beep indicates that the partition has armed; a double beep indicates that the partition hasdisarmed. 3 beeps indicate that the partition is not ready to arm.If the phone in access has been set up to access the full menu, please refer to the table 5 and select therequired operation.