IDS X64 Installer Manual

Also see for X64: Training manual User manual User manual Installer manual Manual

Contents

IDS X64 Installer Manual Manual pdf 14 page image

Section: 2IDS X64 Remote Receiver 700-408-02A Issued August 201014Zone LED Property Zone LED Property1 Relay 1 92 Relay 2 103 Arm / Disarm 114 Stay Arm 125 Panic 136 147 158 1611. Enter [PROPERTY NUMBER] you would like to toggle, followed by the [*] key.NOTE:Arm/disarm, stay arm, and panic are mutually exclusive, selecting one de-selects the others.To confirm if arm/disarm is set for button 1, LED 3 will be on and LED 4 will be off. If stay is set forbutton 1, then LED 3 will be off and LED 4 will be on. If button 1 is the panic, then both LEDs 3and 4 will be on.12. Press the [*] key to set the button properties for the next button.13. Once you have finished, press the [#] key to exit programming.NOTE:If you press a number greater than 5 for the button property, the keypad will beep indicating an illegalentry.2.9 Set Remote Receiver Relay PropertiesUse the following steps to set the Remote Receiver relay properties.[*] [Master Code] [*] [2] [4] [*] [Receiver Number] [*] [Relay Number] [*] [Property Number][*] [#]LCD Keypad1. Hold the [*] key until the beep (3-4 seconds).2. The keypad displays “Master Code + *”.3. Enter [MASTER CODE] followed by the [*] key.4. The keypad displays “Option Menu”, “Add User Code”.5. Enter [2] [4] followed by the [*] key.6. The keypad displays “Receiver Num + *”.7. Enter [RECEIVER NUMBER], which could be 1, 2, 3, or 4, followed by the [*] key.8. The keypad displays “Relay Num + *”.9. Enter [RELAY NUMBER], which could be 1 or 2, followed by the [*] key.10. The keypad displays “Remote Receivr N”, “R Secure RS”.11. At the keypad you can scroll through the properties with the “>>” and “<<” keys. Use [*] totoggle properties.12. Once you have finished, press the [#] key to exit programming.