IDS X64 Installer Manual

Also see for X64: Training manual User manual User manual Installer manual Manual

Contents

IDS X64 Installer Manual Manual pdf 20 page image

Section: 2IDS X64 Remote Receiver 700-408-02A Issued August 201020LED Keypad1. Hold the [*] key until the beep (3-4 seconds).2. The READY and ARM LEDs flash alternately.3. Enter [MASTER CODE] followed by the [*] key.4. The READY LED flashes.5. Enter [2] [9] followed by the [*] key.6. The READY and ARM LEDs flash simultaneously.7. Enter [RECEIVER NUMBER], which could be 1, 2, 3, or 4, followed by the [*] key.8. The READY and ARM LEDs flash simultaneously.Zone Led Receiver No. Zone Led Capacity1 9 (x 1 = 0)2 10 (x 2 = 0)3 11 (x 4 = 0) 8+64+1284 12 (x 8 = 8) =2005 13 (x 16 = 0)6 14 (x 32 = 0)7 15 (x 64 = 64)8 16 (x 128 = 128)NOTE:Remote Receiver 1 is indicated by zone LED 1 coming on.Remote Receiver 2 is indicated by zone LED 2 coming on.Remote Receiver 3 in indicated by zone LEDs 1 +2 coming on.Remote Receiver 4 is indicated by zone LED 3 coming on.The keypad will beep 3 times and then repeat the beeps if the receiver is not registered.9. To identify more receivers repeat steps 7 and 8.10. Once you have finished, press the [#] key to exit programming.3. Troubleshooting3.1 Factory SettingsThe Remote Receiver leaves the factory with its memory empty.The Remote Receiver restores its default configuration whenever it finds its memory empty atstartup.Factory settings (empty memory) may be restored by setting all the DIPswitches to "ON", then applying(or re-applying) power. When this is done, the Remote Receiver clears its memory then waits with thered LED quick-flashing in groups of threeR R R R R R R R R R R R R R Runtil the DIPswitch is changed to a valid number. The Remote Receiver then restarts normally.