IDS X64 Installer Manual

Also see for X64: Training manual User manual User manual Installer manual Manual

Contents

IDS X64 Installer Manual Manual pdf 18 page image

Section: 2IDS X64 Remote Receiver 700-408-02A Issued August 2010185. Enter [2] [7] followed by the [*] key.6. The keypad displays “Receiver Num + *”.7. Enter [RECEIVER NUMBER], which could be 1, 2, 3, or 4, followed by the [*] key.8. The keypad displays “Receiver Num + *”, Identifying Rx N”.NOTE:The keypad will beep 3 times and then repeat the beeps if the receiver is not registered.The receiver will flash both its green and red LEDs in sync. The LEDs will be pulsed on for200ms, and then off for 200ms. This will be repeated 50 times resulting in the receiver doing anidentity flash for the duration of 20 seconds.9. To identify more receivers repeat steps 7 and 8.10. Once you have finished, press the [#] key to exit programming.LED Keypad1. Hold the [*] key until the beep (3-4 seconds).2. The READY and ARM LEDs flash alternately.3. Enter [MASTER CODE] followed by the [*] key.4. The READY LED flashes.5. Enter [2] [7] followed by the [*] key.6. The READY and ARM LEDs flash simultaneously.7. Enter [RECEIVER NUMBER], which could be 1, 2, 3, or 4, followed by the [*] key.8. The ARM and AWAY LEDs flash simultaneously, and the READY and POWER LEDs flashsimultaneously.NOTE:The keypad will beep 3 times and then repeat the beeps if the receiver is not registered.The receiver will flash both its green and red LEDs in sync. The LEDs will be pulsed on for200ms, and then off for 200ms. This will be repeated 50 times resulting in the receiver doing anidentity flash for the duration of 20 seconds.9. To identify more receivers repeat step 7.10. Once you have finished, press the [#] key to exit programming.NOTE:Remote Receiver 1 is indicated by zone LED 1 coming on.Remote Receiver 2 is indicated by zone LED 2 coming on.Remote Receiver 3 in indicated by zone LEDs 1 +2 coming on.Remote Receiver 4 is indicated by zone LED 3 coming on.2.13 Remote Receiver TestUse the following steps to test the remote receiver.NOTE:This command puts the Remote Receiver into test mode for a few minutes. While in test mode, the X64Alarm Panel ignores buttons pressed on known Remote Transmitters, and the keypad displays their usercodes.[*] [Master Code] [*] [2] [8] [*] [Receiver Number] [*] [#]