IDS X64 Installer Manual
Also see for X64: Training manualUser manualUser manualInstaller manualManual
                        | |
Contents
| 
Section: 1IDS X64 Remote Receiver 700-408-02A Issued August 2010 51.3 Wiring and ConfigurationNOTE:The amber LED will be a steady on when it is connected to the Bus. If it is off, then there is a problem.The green LED flashes when in standby mode.1.4 InstallationChoose a location for the Remote Receiver: as high as possible accessible for installation and maintenance accessible for X64 wiring accessible for wiring to controlled devices suitable for antenna1. Straighten the antenna. It should not be kinked or coiled or rolled into a ball, and it should not lieagainst metal. Hanging is best, but lying on wood is also fine.2. Mount the Remote Receiver, using fasteners (woodscrews etc) through the tabs at each end ofthe base plate.3. Remove the Remote Receiver cover.4. The power and data terminals of the Remote Receiver should be connected to thecorresponding terminals of the X64 Alarm Panel, or the nearest keypad or zone expander. Toavoid mistakes, use sheathed cable with 4 colour-coded cores, and connect identically at eachend:12V REDGND BLACK |
Related manuals for IDS X64
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine