PICOe-PV-D510 User ManualPage 43way that the notch in the middle of the SO-DIMM must be aligned with theplastic bridge in the socket.Step 3: Insert the SO-DIMM. Push the SO-DIMM chip into the socket at an angle. (SeeFigure 4-1)Step 4: Open the SO-DIMM socket arms. Gently pull the arms of the SO-DIMM socketout and push the rear of the SO-DIMM down. (See Figure 4-1)Step 5: Secure the SO-DIMM. Release the arms on the SO-DIMM socket. They clip intoplace and secure the SO-DIMM in the socket.Step 0:4.4.2 CF Card InstallationNOTE:The PICOe-PV-D510 can support both CF Type I cards and CF Type IIcards. For the complete specifications of the supported CF cardsplease refer to Chapter 2.To install a CF card (Type I or Type II) onto the PICOe-PV-D510, please follow the stepsbelow:Step 1: Locate the CF card socket. Place the PICOe-PV-D510 on an anti-static padwith the solder side facing up. Locate the CF card.Step 2: Align the CF card. Make sure the CF card is properly aligned with the CFsocket.Step 3: Insert the CF card. Gently insert the CF card into the socket making sure thesocket pins are properly inserted into the socket. See Figure 4-2. Step 3:
