uIBX-200-VX800 Embedded SystemPage 52Î Disabled The console is not redirected after POSTÎ Boot Loader Redirection is active during POST and during BootLoaderÎ Always D EFAULT Redirection is always active (Some OSes may notwork if set to Always) Terminal Type [ANSI]Use the Terminal Type BIOS option to specify the remote terminal type.Î ANSI D EFAULT The target terminal type is ANSIÎ VT100 The target terminal type is VT100Î VT-UTF8 The target terminal type is VT-UTF85.3.6 USB ConfigurationUse the USB Configuration menu (BIOS Menu 11) to read USB configuration informationand configure the USB settings.BIOS SETUP UTILITYMain Advanced PCIPNP Boot Security Chipset ExitUSB Configuration⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯Module Version – 2.24.3-13.4USB Devices Enabled:NoneUSB Functions [Enabled]USB 2.0 Ports Enable [Enabled]Legacy USB Support [Enabled]USB 2.0 Controller Mode [HiSpeed]Enables support forlegacy USB. AUTOoption disableslegacy support ifno USB devices areconnectedÅÆ Select Screen↑ ↓ Select ItemEnter Go to SubScreenF1 General HelpF10 Save and ExitESC Exitv02.61 ©Copyright 1985-2006, American Megatrends, Inc.BIOS Menu 11: USB Configuration USB Function [Enabled]When enabled, USB devices can be used in the USB slots.
