uIBX-200-VX800 Embedded SystemPage 72NOTE:The setup procedures described below are for Microsoft Windowsoperating system users. For Linux system, most setup procedures arethe same with Microsoft Windows except for several steps which isdescribed in Section A.3.A.2.1 Hardware and BIOS SetupStep 1: Make sure the system is powered off and unplugged.Step 2: Install a hard driver or SSD in the uIBX-200-VX800. An unformatted andunpartitioned disk is recommended.Step 3: Connect an optical disk drive to the uIBX-200-VX800 and insert the recoveryCD.Step 4: Turn on the system.Step 5: Press the <DELETE> key as soon as the system is turned on to enter the BIOS.Step 6: Select the connected optical disk drive as the 1 st boot device. (Boot Æ BootDevice Priority Æ 1 st Boot Device).Step 7: Save changes and restart the computer. Continue to the next section forinstructions on partitioning the internal storage.Step0:A.2.2 Create PartitionsStep 1: Put the recovery CD in the optical drive.Step 2: Turn on the system.Step 3: When prompted, press any key to boot from the recovery CD. It will take a whileto launch the recovery tool. Please be patient.Step 4: The recovery tool setup menu is shown as below.