IKEA EVENTUELL Installation Instructions And Use & Care Manual

Contents

102. Locate side mounting bracket flush to the bottom of the cabinetside and against the inside of the front cabinet face. Orient thebracket as shown in the following illustration. Drill ¹⁄₈" (3 mm)pilot holes in 8 places, attach a bracket using four 4.5 x 13 mm#2 Phillips screws to each side of the cabinet, and tighten.Additional plastic washers in hardware package are supplied asspacers for cabinet walls thinner than ½" (13 mm).Cabinet Venting Preparation1. Complete cabinet preparation following the instructions foryour type of venting. Determine venting cutout locations andcut out vent openings in the cabinets, walls and/or soffit.Venting Outside Through the RoofMeasure and mark the lines as shown. Use a saber saw orkeyhole saw to cut an opening through the top of the cabinetand the roof for the vent.Go to Step 2.*NOTE: For 12" (30.5 cm) high cabinets a 6¼" deep x 8" wide(15.9 cm x 20.3 cm) rectangular opening in the cabinet top isrequired for damper transition clearance.Venting Outside Through the WallInstall the 6" (15.2 cm) vent transition to the top of the rangehood liner using two 3.5 x 9.5 mm T10 screws. Assemble thevent duct that you will use over the 6" (15.2 cm) venttransition. Measure from the bottom of the range hood liner tothe horizontal centerline of the vent opening (A).Remove the vent duct from the range hood liner.Transfer measurement A to the cabinet back wall. Measurefrom the underside of the cabinet. Mark the cutout as shown.Use a saber saw or keyhole saw to cut a round openingthrough the back of the cabinet and the exterior wall for thevent.Go to Step 2.Bracket Orientation for 30" (76.2 cm) CabinetA. 30" (76.2 cm) cabinetB. Screws - 4.5 x 13 mm #2 Phillips (8)C. Metal washers (optional)D. Mounting bracket (2) (position for 30" [76.2 cm] cabinet)A. CutoutB. 6¼" (15.9 cm)*C. 7³⁄₄" (19.7 cm) centerline to cabinet frontD. CenterlineABCDDA B* CA. Measurement AB. Horizontal centerline of vent openingC. 3.5 x 9.5 mm T10 screwsD. Range hood linerA. Measurement AB. CenterlineC. 6¼" (15.9 cm) round cutoutABDCBAC