IKEA EVENTUELL Installation Instructions And Use & Care Manual

Contents

12Install Range Hood1. Using 2 or more people, lift the hood liner into its mountedlocation. Attach with four 4.2 x 19 mm #2 Phillips screws intothe slotted openings. Do not tighten screws.2. If needed, insert up to three (3) spacers between each side ofthe canopy and the mounting plate to space and center thecanopy in the cabinet. Align the bottom of the canopy withthe bottom of the cabinet. Install four 4.2 x 19 mm #2 Phillipsscrews into the round mounting plate openings and tighten all(8) mounting screws.3. Remove the metal grease filters from the face panel. See the“Range Hood Care” section.4. Attach the face panel to the hood liner. (The 30" x 12"[76.2 cm x 30.5 cm] cabinet size is shown.)See instructions below for your specific cabinet size.For cabinet size - 30" x 12" (76.2 cm x 30.5 cm)Attach the 30" x 12" (76.2 cm x 30.5 cm) face panel (suppliedwith range hood) to the hood liner using four 3.5 x 9.5 mmflat-head screws and two 4.2 x 15 mm truss head screws.Tighten to secure.For cabinet size - 30" x 15" (76.2 cm x 38.1 cm)Assemble the face panel rear extension to the 30" x 12"(76.2 cm x 30.5 cm) face panel using eight 4.2 x 8 mmscrews.Attach the 30" x 15" (76.2 cm x 38.1 cm) face panelassembly to the hood liner using four 3.5 x 9.5 mm flat-headscrews and two 4.2 x 15 mm truss head screws. Tighten tosecure.5. Connect the lamp electrical connectors.A. CabinetB. Hood liner canopy assemblyC. Screws - 4.2 x 19 mm #2 Phillips (8)D. Spacer - optionalAB CDA. Screws - 3.5 x 9.5 mm flat-head (4)B. Face plate (30" x 12" [76.2 cm x 30.5 cm] shown)C. Cabinet (30" x 12" [76.2 cm x 30.5 cm] shown)D. Screws - 4.2 x 15 mm truss-head (2)A. Screws - 4.2 x 8 mm (8)B. Face panelC. Face panel rear extensionABCDABCA