IKEA EVENTUELL Installation Instructions And Use & Care Manual

Contents

11Non-Vented (recirculating) Installation Through theSoffit/CabinetMeasure and mark the centerline location for the cutout in thecabinet top. Use a saber saw or keyhole saw to cut anopening for the vent.Measure and mark the centerline of the cabinet to the soffitabove.Measure from the bottom of the cabinet to the centerline ofthe where the vent will come through the soffit. Mark thelocation and use a saber saw or keyhole saw to cut a 5¾"(14.6 cm) hole for the vent cover. Attach the vent cover usingtwo 4.5 x 13 mm #2 Phillips screws.For non-vented (recirculating) installations only, the rangehood can be vented indoors through the top of the cabinet.For non-vented (recirculating) installations, charcoal filters arenecessary. See the “Range Hood Care” section forinstructions on installing charcoal filters.The Charcoal Filter Kit Part Number W10272068 must beused.Complete Preparation2. If it is not yet attached, install the 6" (15.2 cm) vent transitionto the top of the range hood liner using two 3.5 x 9.5 mm T10screws.3. Install the vent system according to the method needed. Usecaulking to seal the exterior wall or roof opening.A. CutoutB. Vent cover (installation without soffit)C. See the following chart.D. 7³⁄₄" (19.7 cm) centerline to cabinet frontE. CenterlineCabinet Height Hole Shape and Size12" (30.5 cm) A 6¼" deep x 8" wide (15.9 cm x 20.3 cm)rectangular opening in the cabinet top isrequired for damper transition clearance.15" (38.1 cm)cabinet or soffitinstallationA 6¼" (15.9 cm) diameter round opening isrequired.18" (45.7 cm) or24" (61.0 cm)A 5¾" (14.6 cm) diameter round opening isrequired.EA C DBA. Vent coverB. CenterlineA. Vent transitionB. 3.5 x 9.5 mm T10 screwsA BAB