Icom IC-7100 Basic Manual
Also see for IC-7100: Finger touch operationSpecificationService manualAdvanced instructionsInstruction manual
                                                                                                | |
Contents
| 
2INSTALLATION AND CONNECTIONS2-7Power Supply ConnectionsConnect topower supplyFor European versionsOPC-2095GNDDC power socketMake sure the [PWR] (L) switch is OFF before con-necting the DC power cable.• We recommend using Icom’s optional power supply(PS-126: DC13.8 V/25 A).D Connecting the PS-126 power supplyRear panelGNDPS-126Use the attached AC cable to con-nect to AC outlet.To[DC 13.8V]The transceiver needs followings:• DC 13.8 V (Capacity: 22 A and over)• A power supply with an over current protective lineand with a less voltage fluctuation or rippleD Connecting a non-Icom DC power supplyConnect the black DC power cable to the (–) Negativeterminal, and the red DC power cable to the (+) Positiveterminal.Rear panelGNDDC power socketFuseholderRED BLACKStabilized power supplyAC outletOPC-1457RWARNING! (About DC power supply)• Make sure DC power cable polarity is correct.Red: Positive + terminalBlack: Negative – terminal• NEVER cut the DC power cable between the DCplug and fuse holder.• DO NOT use unattached or undesignated DC pow-er cable.• DO NOT forcibly pull or bend the DC power cable.Install the devices far enough from the place wherepeople might put things or step on the DC powercable.The L, R, C or D in theinstructions indicate thepart of the controller.L: Left sideR: Right sideC: Center bottomD: Display (Touch screen)Left RightCenterDisplay |
Related manuals for Icom IC-7100
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine