Icom IC-7100 Basic Manual

Also see for IC-7100: Finger touch operation Specification Service manual Advanced instructions Instruction manual

Contents

Icom IC-7100 Basic Manual Manual pdf 42 page image

3 BASIC OPERATION3-10Setting frequency (Continued)1/4 tuning step functionD(Mode: SSB-D/CW/RTTY)The dial speed is reduced to 1⁄4 of the normal speedwhen the 1⁄4 tuning function is ON, for finer tuning con-trol.You can set the 1⁄4 tuning function in each operatingfrequency band.This function is selectable only when the quick tuningfunction is turned OFF.Pushq MENU (C) one or more times to select the“M-2” screen (M-2 menu).Touch [1/4](w D) to turn the 1⁄4 tuning function ON orOFF.• “ ” appears when the 1⁄4 tuning function is ON.Auto tuning step functionDWhen you rapidly rotate the Dial, the tuning speed canautomatically accelerate, depending on the “MAIN DIALAuto TS” option in the “Function” Set mode.Pushq SET (C) to enter the Set mode.Touch the “MAIN DIAL Auto TS” item of the “Func-wtion” Set mode.Function > MAIN DIAL Auto TS• If the specified item is not displayed, touch [Y] or [Z](D)one or more times to select the page.Touch the desired option to selecte the HIGH or LOWtuning speed acceleration, or to turn OFF the func-tion.• HIGH: When the tuning step is set to 1 kHz or small-er steps, the tuning speed is approximately fivetimes faster.When the tuning step is set to 5 kHz or largersteps, the tuning speed is approximately two timesfaster. (default)• LOW: Approximately two times faster• OFF: Auto tuning step is turned OFF.• If desired, touch the item for 1 second to open the Defaultset window, then select the “Default” to reset to the de-fault setting.Pushr SET (C) to exit the Set mode.The L, R, C or D in the instructions indicate thepart of the controller.L: Left side, R: Right side, C: Center bottomD: Display (Touch screen)Touch [1/4]¹⁄₄ tuning iconTouch“Function”Touch “MAINDIAL Auto TS”Push SETHIGH (Default)