5D-STAR OPERATION 5-3D-STAR Operating procedures (Continued)Making a Gateway callD Set “FROM” (Access repeater)1.Pushq DR (C) to select the DR mode.Check whether or not “FROM” is selected.w• If “FROM” is not selected, touch the “FROM” field.Touch the “FROM” field.e• The “FROM SELECT” screen appears.Touch “Repeater List.”r• The “REPEATER GROUP” screen appears.Touch the repeater group where your access repeat-ter is listed.• Example: “11: Japan”Touch your access repeater.y• Example: “Hirano”• The transceiver returns to the DR mode screen, and theselected repeater is set in “FROM.”Set “TO” (Destination)2.Check whether or not “TO” is selected.u• If “TO” is not selected, touch the “TO” field.Touch the “TO” field.i• The “TO SELECT” screen appears.Touch “Gateway CQ.”o• The “REPEATER GROUP” screen appears.!0 Touch the repeater group where your destination re-peater is listed.• Example: “11: Japan”!1 Touch the destination repeater.• Example: “Hamacho”• The transceiver returns to the DR mode screen, and theselected repeater is set in “TO.”Hold down [PTT] to transmit3.• While holding down [PTT], the TX/RX indicator lights red.“FROM” is selected.“Hirano” is setin “FROM.”Touch“FROM.”Touch your ac-cess repeater.( Example:“Hirano”)The L, R, C or D in theinstructions indicate thepart of the controller.L: Left sideR: Right sideC: Center bottomD: Display (Touch screen)Left RightCenterDisplayTouch“Gateway CQ.”TransmittingTouch“TO.”“Hamacho” isset in “TO.”“TO” is selected.Touch the re-peater group( Example:“11: Japan”)Touch the desti-nation repeater.( Example:“Hamacho”)Repeater area(Sub name)Repeatercall signSee page 5-5 to check whether you can access therepeater.Convenient!✓The Gateway CQ call is used to call any repeater, butyou can call a specific station by simply saying theircall sign.
