163 BIIS OPERATION Transmitting a callA total of 3 ways for code selection are available—selectingthe call code from memory, entering the call code from thekeypad and calling back from the queue channel record.DD Using call memoryq While in the standby condition, push [P1] (Digital) to enterthe call code memory channel selection mode.• “ ” appears.w Push [Up] or [Down], or rotate [DIAL] to select the desiredcall code.e Push [P0] (Call) or [PTT]* to call.*PTT call can be made only when PTT call capability is permitted.NOTE: When no answer back is received, the trans-ceiver repeats the call 3 times (default) automatically,and “WAIT” is displayed during each call. However, anerror beep sounds and “FAILED” is displayed when noanswer back is received after the calls.r Push [PTT] to transmit; release to receive.t Push [P4] (Moni(Audi)) to send the ‘Clear down’ signal.DD Calling back from the queue channelq While in the standby condition, push [P1] (Digital) for1 sec. to enter the queue memory channel selection mode.w Push [Up] or [Down] or rotate [DIAL] to select the desiredrecord.e Push [P0] (Call) or [PTT]* to call.*PTT call can be made only when PTT call capability is permitted.NOTE: When no answer back is received, the trans-ceiver repeats the call 3 times (default) automatically,and “WAIT” is displayed during each call. However, anerror beep sounds and “FAILED” is displayed when noanswer back is received after the calls.r Push [PTT] to transmit; release to receive.t Push [P4] (Moni(Audi)) to send the ‘Clear down’ signal.< Q U E U E >- Q U E U E ! -C A L L I N G0 5 0 0Appears

explicit definitions

panel description

I Function display

I Programmable function keys

I Channel selection

I Call procedure

D Transmitting notes

D TX code number edit

D Individual ID code selection

I Scrambler function

I Receiving a call

D Group call

I Transmitting a call

D Direct code entry

D Receiving a status message

D Received message selection

I Transmitting a status

D General

D Programming an SDM memory

I Position data transmission

I Stun function

connection and maintenance

I Supplied Accessories

I Mounting the transceiver

I Optional UT-109 or UT-110 installation

I Antenna

SAFETY TRAINING INFORMATION

Icom IC-F1721 Instruction Manual

IC-F1721

i programmable function keys

mdc 1200 operation

i receiving a call

IC-F1721D

IC-F1821

IC-F1821D

IC-F2721

IC-F2721D

IC-F2821

IC-F2821D