Icom IC-F1721 Instruction Manual

Also see for IC-F1721: Instruction manual Operating guide

Icom IC-F1721 Instruction Manual Manual pdf 26 page image

223 BIIS OPERATIONDD Programming an SDM memory(IC-F1821/D or IC-F2821/D only)q During standby condition, push [P1] (Digital) twice, thenpush [Up] or [Down] to select the desired SDM to be edit-ed.w Push [M] or [#] to enter the message editing condition.• The first character blinks when [#] is pushed, the last characterblinks when [M] is pushed.• “ ” blinks.e Push the appropriate digit key, [0] to [9], to enter thedesired character.• See the table at right for the available characters.• Pushing [UP] also enters space, pushing [DOWN] deletes theselected character.r Push [#] to move the cursor to the right, push [M] to movethe cursor to the left.t Repeat steps e and r to set the desired text message.y Push [P1] (Digital) for 1 sec. to overwrite the set contentinto the memory.• Push [P1] (Digital) momentarily to cancel the editing and return tothe original message indication.• Available charactersNOTE: A decimal point can only be written with the CS-F1700 CLONING SOFTWARE . Pre-programmed characterscan be rewritten with the 10-keypad, except for the deci-mal point, as it is not included in the transceiver characterlist, and cannot be displayed again.Key[0][1][2][3][4][5][6][7][8][9]Characters0 ! ? ' " , ; : _ ( ) < > [ ]1 (space) # * / + - = & % $ @ ^2 A B C a b c3 D E F d e f4 G H I g h i5 J K L j k l6 M N O m n o7 P Q R S p q r s8 T U V t u v9 W X Y Z w x y z/!M E S S A G E 8S D M 8BlinksBlinksWhen [#] is pushed.