Icom IC-F1721 Instruction Manual

Also see for IC-F1721: Instruction manual Operating guide

Icom IC-F1721 Instruction Manual Manual pdf 21 page image

173BIIS OPERATION3DD Direct code entryq While in the standby condition, push [P3] (TX Code Enter)to enter the TX code edit mode.• Code digit for editing blinks.w Push [P3] (TX Code Enter) to select the desired digit to beedited.• Digit for editing differs according to the setting.e Set the desired digit using [CH Up]/[CH Down]/[DIAL] or10-keypad*.*IC-F1821/D or IC-F2821/D onlyr Push [P3] (TX Code Enter) to set the digit, then the digitto the right will blink automatically.• When the 10-keypad is used for setting, the digit to the right willblink automatically without pushing [P3] (TX Code Enter).t Repeat e and r to input all allowable digits.y Push [P0] (Call) or [PTT]* to call.*PTT call can be made only when PTT call capability is permitted.NOTE: When no answer back is received, the trans-ceiver repeats the call 3 times (default) automatically,and “WAIT” is displayed during each call. However, anerror beep sounds and “FAILED” is displayed when noanswer back is received after the calls.u Push [PTT] to transmit; release to receive.i Push [P4] (Moni(Audi)) to send the ‘Clear down’ signal.For your informationWhen the “UpDate” setting for the call code is enabled, theset code is overwritten into the call code memory.0 5 0 0