Icom IC-F6062D Operating Manual

Also see for IC-F5062D: Instruction manual Instruction manual Instruction manual Instructions

Contents

Icom IC-F6062D Operating Manual Manual pdf 17 page image

143dPMR OPERATION 3161514131211109876542114D Receiving a Group callq When a Group call is received:• Rings sound.• “ ” appears and the mute is released.• “ ” appears or blinks, depending on the pre-programmed set-tings.• The Talkgroup ID (or name) and the calling station’s ID (or name)blink.• When an All Call is received, “ALL CALL” blinks instead of “TG”and the Talkgroup ID.T G 0 1 0 0 0 0 0I D 0 0 0 0 0 0 1Calling station’s IDTalkgroup IDAppears or blinksAppearsw While holding down [PTT], speak into the microphone atyour normal voice level.NOTE: Only one station is allowed to speak at thesame time.e Release [PTT] to receive.r After the communication is finished, push [Clear] to senda ‘Disconnect’ signal to terminate the connection.• Either station can send a ‘Disconnect’ signal.• “ ” disappears, “CLR DOWN” appears for approximately 2seconds, and the transceiver automatically returns to thestand-by mode.D Receiving a status messageq When a status message is received:• Rings sound.• The calling station’s ID (or name) and the status messageblink.R X S T A T U S 0 1I D 0 0 0 0 0 0 1The receivedstatus messageCalling station’s IDw Push [Clear] to return to the stand-by mode.