Icom IC-F6062D Operating Manual

Also see for IC-F5062D: Instruction manual Instruction manual Instruction manual Instructions

Contents

Icom IC-F6062D Operating Manual Manual pdf 4 page image

11 PREPARATION■ Programmable function keysThe following functions can be assigned to [UP], [DOWN],[P0], [P1], [P2], [P3] and [P4] programmable function keys.Consult your Icom dealer or system operator for details con-cerning your transceiver’s programming.If the programmable function names are bracketed in the fol-lowing explanations, the specific key is used to activate thefunction.D For only BIIS 1200 operationThe following key function is required for BIIS 1200 operation.BIIS BUTTON➥ Push to enter the call code memory mode.• Push [CH Up] or [CH Down] to select a desired Individual orGroup ID.➥ While in the call code memory mode, push to enter themessage selection mode.• Push [CH Up] or [CH Down] to select a desired status messageor Short Data Message (SDM).➥ While in the message selection mode, push to return to thestand-by mode.➥ Hold down for 1 second to toggle between the memorychannel mode and the queue channel mode.➥ While in the queue channel mode, push to toggle betweenthe queue channel mode and the received messagemode.“” appears above the key assigned to the BIIS Buttonfunction, when it is activated.D For only dPMR operationThe following key functions are required for dPMR operation.dPMR BUTTON➥ Push to enter the ID selection mode.• Push [CH Up] or [CH Down] to select a desired Individual orTalkgroup ID.➥ While in the ID selection mode, push to enter the applicationselection mode.• Push [CH Up] or [CH Down] to select a desired application from“STATUS,” “MESSAGE,” “STAT POL,” “LISTENING,” “STUN,”“KILL,” “REVIVE” and “CALL LOG.”➥ If you select “STATUS” or “MESSAGE” in the application selec-tion mode, push to enter the message selection mode.• Push [CH Up] or [CH Down] to select a desired message.➥ While in the application selection mode, push to return tothe stand-by mode.CLEARAfter communication is finished, push this key to send a ‘Dis-connect’ signal to terminate the connection.Depending on the pre-programmed settings, the Priority Achannel is automatically selected after a ‘Disconnect’ sig-nal terminates a connection.