Icom IC-M506 Instruction Manual

Also see for IC-M506: Specifications Instruction manual Service manual Instruction manual Service manual

Contents

Icom IC-M506 Instruction Manual Manual pdf 17 page image

83PREPARATION12345678910111213141516MMSI code programming■The 9 digit MMSI (Maritime Mobile Service Identity: DSC selfID) code can be programmed at power ON.This initial code setting can be performed only once.After being set, it can be changed by only your dealeror distributor. If your MMSI code has already been pro-grammed, this programming is not necessary.Hold down [PWR](Dial) to turn ON the power.q• Three short beeps sound, and “NO DSC MMSI” is displayed.Push [ENT] to start the MMSI code programming.w• Push [CLEAR] twice to cancel the programming, and go to thenormal operating screen. In this case, the transceiver cannotmake a DSC call. To program the MMSI code, turn OFF thepower, then turn it ON again.Enter your MMSI code in the following manner:e• Select a desired number using [Y]/[Z]/[Ω]/[≈].• Push [ENT] or dial to set it.• To move the cursor, rotate dial or select either arrow, “←” or “→,”then push [ENT] or dial.Repeat stepr e to enter all 9 digits.After entering the 9 digit code, “FINISH” is automaticallytselected, and then push [ENT] or dial to set it.The “MMSI CONFIRMATION” screen is displayed.yEnter your MMSI code again for confirmation.u• Enter in the same manner as steps e through t.When your MMSI code programming is successfully com-ipleted, the screen as shown below is briefly displayed.• After that, the normal operating screen is displayed.The programmed MMSI code can be checked in the MENUscreen. (p. 92)