offered by Busse-Yachtshop.com Receiving and transmittingCAUTION: Transmitting without an antenna may dam-age the transceiver.q Push [POWER] to turn power ON.w Set the audio and squelch levels.➥ Rotate [SQL] fully counterclockwise in advance.➥ Rotate [VOL] to adjust the audio output level.➥ Rotate [SQL] clockwise until the noise disappears.e To change the channel group, push [DIAL] while pushing[H/L]. (p. 9)r Rotate [CHANNEL] or push [Y]/[Z] on the microphone toselect the desired channel.• When receiving a signal, “BUSY” appears and audio is emittedfrom the speaker.• Further adjustment of [VOL] may be necessary at this point.t Push [H/L] to select the output power if necessary.• “25W” or “1W” appears when high or low power is selected, re-spectively.• Choose low power to reduce an intermodulation for other sta-tions, choose high power for longer distance communications.• Some channels are for low power only.y Push and hold [PTT] to transmit, then speak into the mi-crophone.• “TX” appears.• Channel 70 cannot be used for transmission.u Release [PTT] to receive.IMPORTANT: To maximize the readability of your trans-mitted signal, pause a few sec. after pushing [PTT], holdthe microphone 2.5 to 5 cm from your mouth and speak ata normal voice level.VOLiM601VHF MARINEMICCSQL16/Cweq rrt y u3 BASIC OPERATION10