Icom IC-M602 Instruction Manual

Also see for IC-M602: Instruction manual Service manual Instruction manual Service manual

5SCAN OPERATION17PushSCNGHIthenScan starts. When a signal is receivedBUSY-25W---INT---CALLLOCAL--DUPSCRAM--TAGNORMAL-SCAN-34°34.206N123°23.236W--UTC-10:10---INTL-BUSY-25W---INT---CALLLOCAL--DUPSCRAM--TAGNORMAL-SCAN-34°34.206N123°23.236W--UTC-10:10---INTL-4BUSY-25W---INT---CALLLOCAL--DUPSCRAM--TAGNORMAL-SCAN-34°34.206N123°23.236W--UTC-10:10---INTL-[Example]: Starting a normal scan. Setting tag channelsFor more efficient scanning, add desired channels as tagchannels or clear tag channels for unwanted channels. Chan-nels are not tagged will be skipped during scanning. Tagchannels can be assigned to each channel group (U.S.A., In-ternational, Canada) independently.q While pushing [H/L], push [CH/WX•U/I/C] one or moretimes to select the desired channel group.w Select the desired channel to be set as a tag channel.e Push [F], then push [5 TAG] to set the displayed channelas a tag channel.• “TAG” appears in the display.r To cancel the tag channel setting, repeat step e.• “TAG” disappears.Convenient: Clearing all tagged channels➥ While pushing [H/L], push [5 TAG ] for 3 sec. (until a longbeep changes to 2 short beeps) to clear all tag channels inthe channel group. Starting a scanSet scan type (priority or normal scan) and scan resume timerin advance using set mode. (p. 51)q Set tag channels as described at left.w Make sure the squelch is closed to start a scan.e While pushing [H/L], push [CH/WX•U/I/C] one or moretimes to select the channel group, if desired.r Push [F], then push [4 SCN] to start priority or normal scan.• “PRI-SCAN 16” or “NORMAL SCAN” appears in the functiondisplay.• When a signal is detected, scan pauses until the signal disap-pears or resumes after pausing 5 sec. according to set mode set-ting. (Channel 16 is still monitored during priority scan.)• Rotate [CHANNEL] to check the scanning tag channels, tochange the scanning direction or resume the scan manually.• “16” blinks and a beep tone sounds when a signal is receivedon Channel 16 during priority scan.t To stop the scan, push [CLR] or repeat step r.5