72 SETTING A FREQUENCY Tuning step selectionWhen using the tuning dial to change the frequency, or whena scan function is activated, the frequency changes in incre-ments determined by the set tuning step. This can bechanged if desired.The following tuning step are available.• 1 Hz • 10Hz • 20 Hz • 50 Hz • 100 Hz• 500Hz • 1 kHz • 2.5 kHz • 5 kHz • 6.25 kHz• 8.33 kHz • 9 kHz • 10 kHz • 12.5 kHz • 15 kHz• 20 kHz • 25 kHz • 30 kHz • 50 kHz • 100 kHz• 125 kHz • 150 kHz • 200 kHz • 500 kHz • 1 MHz• 10 MHzq Push [V/MHz•SCAN] to select VFO mode, if necessary.w Push [TS•MODE] to enter the tuning step select mode.r Rotate [DIAL] to select the desired tuning step.tPush [TS•MODE] to exit the tuning step select mode. Setting a frequencyq Rotate [DIAL] to set the frequency.• If VFO mode is not selected, push [V/MHz•SCAN] to select VFOmode.• The frequency changes in the selected tuning steps. (p. ??)wTo change the frequency in 1 MHz (10 MHz for some ver-sions) steps, push [V/MHz•SCAN], then rotate [DIAL].• Pushing [V/MHz•SCAN] for 1 sec. starts scan function. If scanstarts, push [V/MHz•SCAN] again to cancel it.While 1 MHz tuning step isselected, the digit below100 kHz disappear.While 10 MHz tuning step isselected, the digit below 1MHz disappear.[DIAL][V/MHz•SCAN][DIAL][TS•MODE][V/MHz•SCAN]