Icom IC-R2500 Instruction Manual

Also see for IC-R2500: Price list Service manual Instruction manual

Icom IC-R2500 Instruction Manual Manual pdf 16 page image

113 SETTING A FREQUENCY■ Using the tuning dialq Rotate the desired band’s [DIAL] to set the frequency.• If VFO mode is not selected, push the same band’s[VFO/MR•S.MW] to select VFO mode.• The frequency changes in the selected tuning steps. (p. 14)wTo change the frequency band or in 1 MHz (10 MHz) steps,push [MHz•TS], then rotate the band’s [DIAL].ePush [MHz•TS] to exit tuning step select mode.■ Receive mode selectionReceive modes are determined by the physical properties ofthe radio signals. The receiver has 7 receive modes: LSBUSB, CW, AM, WFM, FM and digital modes. The mode se-lection is stored independently in each memory channels.Typically, AM mode is used for the AM broadcast stations(0.495–1.620 MHz) and air band (118–135.995 MHz), andWFM is used for FM broadcast stations (76–107.9 MHz).q Push [MODE•SCAN] to enter receive mode select mode.w Rotate [DIAL] to select the desired mode.ePush any switch to exit receive mode select mode.[DIAL][MODE•SCAN]While the band selection mode is selected,the digits below 100 kHz disappear.While 1 MHz tuning step isselected, the 1 MHz digitblinks.While 10 MHz tuning step isselected, the 10 MHz digitblinks.Push [VFO/MR•S.MW]Rotate [DIAL]