498 PRIORITY WATCH■ Priority watch operationD Memory/call channel and memory scan watchq Select the VFO mode, then set an operating frequency.w Select the channel(s) to be watched.For memory channel watch:Select a desired memory channel.For call channel watch:Select a desired call channel.For memory scan watch:➥ Select the memory mode, or a desired bank group.➥ Push and hold [SCAN](H/M/L) for 1 sec. to enter thescan type selection mode.➥ Rotate [DIAL] to select a desired scan type, then push[SCAN](H/M/L) again to start the memory/bank scan.ePush [SET] to enter the Set mode.rRotate [DIAL] to select the priority watch set item, thenrotate [VOL] to select “On.”• Select “bELL” if the priority beep function is desired.t Push [V/M/C] to exit the Set mode and start the watch.• The “PRIO” icon appears.• The transceiver checks the memory/bank channel(s) or callchannel every 5 seconds.• The watch resumes according to the selected scan resume set-ting. (p. 47)y Push [V/M/C] to cancel the watch.Monitors VFO frequencyfor 5 seconds.Pauses on a memoryor call channel whena signal is received.• During priority watchA beep tone sounds and “S” icon blinks when a signal isreceived on a memory or call channel.• During priority watch with priority beep
