Icom IC-V8000 Optional Instructions

Also see for IC-V8000: Service manual Instruction manual Service manual Instruction manual

Contents

31 ANI FUNCTION‘‘ OperationD Calling a specific stationq Turn the power ON.w Rotate the tuning dial to select the desired channel.• “A” is displayed beside the channel number on the ANI set channel.e Push [SET(LOCK)] then rotate the tuning dial to select thedesired code channel C1 to C6, or set the 3-digit ANI code,if desired.• Push [TONE(T-SCAN)] to return to the previous conditions.r Push [PTT] to connect to the selected station.• Transmits the pre-programmed station code.t When the transceiver rings (an answer back is received),wait for a connection code from the connected station;when the transceiver doesn’t ring, push [PTT] again to exitthe standby condition, then try again from step e afterwaiting a while.y When the connection code is received, the connectioncode sounds, then “ ” blinks; when the connection codeis not received within 10 sec., the transceiver transmits adisconnect code automatically. Try again from step e afterwaiting a while.u When “ ” blinks, you can converse with the connectedstation.• Push [PTT] to transmit; release to receive.i When your conversation is finished, push [#] while pushing[PTT] (for HM-118TN/TAN), or push [DTMF-S] then[SQLZ #(16KEY-L)] (for HM-133V) to transmit a disconnectcode.NOTE:When your conversation extends into the time-out time, thetransceiver transmits a disconnect code automatically.• ANI operation flow chartTry again after a whileNoNoYesYesReceive ananswer backcodeReceivea connectioncodeTransmita station codeConverseTransmita disconnect codemanuallyPush [PTT] toexit standbyTransmitsdisconnect codeautomatically