Icom IC-V8000 Optional Instructions

Also see for IC-V8000: Service manual Instruction manual Service manual Instruction manual

Contents

41ANI FUNCTIOND Calling group stationsq Select the desired ANI set channel.w When using HM-118TN/TAN:Push [MM] then enter the 3-digit group code. [A] or [D] mustbe included at least once.When using HM-133V:Push [MM(TONE-1)] then enter the 3-digit group code.[CLR A(MW)] or [ SQLY D(MUTE)] must be included at leastonce.• Transmits automatically after the 3rd digit code is entered.• When making group calls, the transceiver does not ring and noanswer back connection code is received.• You can make an announcement to your group immediatelywithout a connection procedure.• “ ” blinks.e Operate the transceiver in the normal way (push [PTT] totransmit; release [PTT] to receive).r When your conversation is finished, push [#] while pushing[PTT] (HM-118TN/TAN), or push [DTMF-S] then [ SQLZ #(16KEY-L)] (HM-133V) to transmit a disconnect code.D Group code examples[Example 1]: If the “11D (11A)” is transmitted, the trans-ceivers with ID codes “110” to “119” are called.[Example 2]: If the “1D3 (1A3)” is transmitted, the trans-ceivers with ID codes “103,” “113,”...“183” and“193” are called.NOTE: When “DDD (AAA)” code is transmitted, all trans-ceivers are called.D Waiting for a callq Select the desired ANI set channel, or push[V//MHz(SCAN)] for 1 sec.w When receiving a selective call, the display changes asbelow, and ringing beeps are heard.e Push [PTT] to send a connection code within 10 sec.• A disconnect code is sent automatically instead of a connectioncode in case [PTT] operation is not performed within 10 sec.r While “ ” blinks, converse with the connected station.• Transmitting the disconnect code from your side (push [#] whilepushing [PTT] or push [DTMF-S] then push [ SQLZ #(16KEY-L)])is also available. (except for group call receive)• “ ” stops blinking.When called from the station“123.”During ANI conversation.