Icom ID-800H Instruction Manual

Also see for ID-800H: Addendum Operating guide Service manual Firmware update Instruction manual

Contents

Icom ID-800H Instruction Manual Manual pdf 103 page image

8611DIGITAL MODE OPERATION11r Push [BAND•MODE] to display the message, then push[SET•LOCK] or [S.MW•MW] several times to scroll themessage.t Push [M/CALL•PRIO], [TONE•T-SCAN•BK], [LOW•DUP]or [MONI•DTMF•EMR] to exit the message set mode.z When the call with a message is received, thedigital message indicator blinks.x Push [ SET B (D-OFF)] to enter message setmode.• Push [YY] or [ZZ] to select “MESSAG” if necessary.c Push [SET B(D-OFF)] or [ENT C (T-OFF)] severaltimes to select “RX-MSG” or “RX-CAL.”• When “RX-CAL” is displayed, push [YY] or [ZZ] to se-lect “RX-MSG,”v Push [BAND] to display the message.b Push [SET B(D-OFF)] or [ENT C (T-OFF)] to scrollthe message.n Push [CLR A(MW)] to exit the message set mode.For your informationWhen “Auto RX message Display (RMD)” (p. 101) is set toON, the received message will be displayed and scrolls auto-matically. Break-in communicationThe break-in function allows you to break into an another sta-tion’s communications in both digital voice and low-speeddata operation.q While receiving an another station’s communication, pushand hold [TONE•T-SCAN•BK] until 2 regular and 2 longbeeps sound to turn the break-in setting ON.• “BK” appears.• When a call sign has not been received correctly, “NoCALL” isdisplayed and “BK” won’t be appears. Receive the call sign in-cluded in a communicating signal again, or set the call sign man-ually in this case.wWhen both stations are in standby, transmit to send abreak-in call.• Programmed call sign station receives the break-in call as wellas your call sign.eWait for the reply call from the station who receives thebreak-in call.r After receiving the reply call, communicate normally.tTo cancel the break-in, push and hold [TONE•T-SCAN•BK]for 1 sec. to turn OFF.SETBScroll indicator appears