11SETTING A FREQUENCY2 PreparationD Turning power ON/OFF➥ Push and hold [PWR] for 1 sec. to turn power ON and OFF.D Operating frequency band selectionThe ID-800H has 2 m and 70 cm bands for transmission andreception. In addition, extra frequency bands 127, 220, 350,500 and 900 MHz bands are available for wide-band receivercapability (except Taiwan and Korean version).➥ Push [BAND•MODE] and rotate [DIAL], then push[BAND•MODE] to select the desired frequency band.➥ Push [BAND] and [YY]/[ZZ], then push [BAND]to select the desired band.D VFO and memory modesThe transceiver has 2 basic operating modes: VFO mode andmemory mode. Select VFO mode first to set an operating fre-quency.➥ Push [V/MHz•SCAN] to select VFO mode.• When VFO mode is already selected, the digit below 10 MHz(the digit below 1 MHz or 100 kHz disappear depending on ver-sions) disappear. In this case, push [V/MHz•SCAN] again (ortwice or 3 times depending on version).➥ Push [M/CALL•PRIO] to select memory mode.• “!” indicator appears when memory mode is selected.➥ Push [VFO/LOCK] to select VFO mode.➥ Push [MR/CALL] to select memory mode.VFO/LOCK[V/MHz•SCAN][M/CALL•PRIO] AppearsBAND[BAND•MODE][PWR]Note that in this manual, sections beginning with a micro-phone icon (as above), designate operation via the HM-133microphone.
