7211Bluetooth® OPERATION11 Bluetooth® OPERATION■ Installing the UT-133When you install the optional UT-133 Bluetooth ® unit in thetransceiver, you can communicate with other Bluetooth®headset.NOTE: Before touching the transceiver or UT-133, removestatic electricity from your body by touching a groundedobject such as a grounded piece of equipment. The staticelectricity from your body may damage the transceiver orthe UT-133, or cause data lost.Turn the transceiver upside-down.qRemove the three screws from the bottom of the trans-wceiver and the four screws from the sides, then lift off thebottom cover.BottomcoverPlace one end the UT-133 under the edge of the front pan-eel, with the connector facing down.ConnectorUT-133Front panelCarefully, push the connector into the socket.r• Ensure the UT-133 is installed correctly.Reattach the bottom cover and screws.tR WARNING! BE SURE TO disconnect the DC power ca-ble before starting the following procedures.
