96Connect Your Child Clock via IP Address1. Press Down to select By IP Address, press Enter.2. Enter the IP address of the Parent Clock, then press Enter.• If connecting over a LAN or WAN, enterthe IP address used for accessing thesoftware interface.Example: 192.168.004.155• If connecting remotely over the Internet, enter the public IP address of the ParentClock’s router, including leading zeros.Example: 074.168.004.155For additional information on connecting your multi-clock system remotely over theInternet, with port-forwarding, refer to Chapter 14: Configure the Time Clock forRemote Access.Continuing Multi-clock Setup1. Once connection is established with the Parent Clock, the Child Clock displays ChildMode, then Enter PIN.2. The symbol ' - ' displays in the top right corner.3. Once the connection is established, the symbol d displays in the top right corner of thedisplay. The d indicates the Child Clock is connected to the Parent Clock, but the ChildClock is disabled and must be enabled through the software interface.4. Log into the Parent Clock using the web browser.5. Go to Lists | Child Clocks.6. Select the Enabled check-box for the Child Clock. Press Submit.7. The Child Clock displays “#’ in the top-right corner of the terminal display indicatingthe Child Clock is communicating with the Parent Clock.8. After a few minutes this will change to “+” indicating that the Child Clock is active andready to use.
