Ideal Boilers mini HE C24 Installation And Servicing

INSTALLATIONmini HE --- Installation & Servicing 1917 MOUNTING THE BOILERLift the boiler onto the wall mounting plate locating the bar atthe rear of the back panel assembly into the bracket.As added protection, the boiler should be lifted with the lowerpolystyrene packaging in place.Lower the boiler into position.Remove the lower packaging. Remove the front and sidepanels (refer to frame 22) and strip off the protective coating.The panels may be placed to one side and re---fitted when theinstallation is complete.Note. Before fitting the flue system, fili the condensate trapwithin the boiler by pouring a cupful of water into the flueoutiet A. Take care to ensure that the water is only poured intothe flue outiet, and does not spill into the boiler casing.Fit the flue system referring to the instructions contained withthe kit.Make good the internal wall surface using the seal provided.A18 CONNECTIONSFit the service valves washers and tail pipes as shown.Central Heating flowDomestic hotwater outlet Gas inletDomestic coldwater inlet Central Heating returnConnect to the tail pipes by proprietory fittings.The pipework may be directed down or through the rear wallas required.The pipework may be directed upwards by using the optionalstand off bracket kit. See illustration for upward pipeworkrouting19 SAFETY VALVE DRAINThe discharge pipe should be positioned so that thedischarge of water or steam cannot create a hazard to theoccupants of the premises or damage to electricalcomponents and wiring.PressureDischarge piperelief valveINSTALLATION